Specifications

5. Refer to Figure 3-21 and disassemble the various parts of the color change cam
assembly to replace the part in question. Leave the pulley and spacer attached
to the left side of the shaft if possible.
6. Refer to Figure 3-21 to reassemble the color change cam assembly parts loosely.
7. Install the color change PCB to put the color change bracket to the form it will
take when completely assembled.
color change
bracket (with cam
and hardware)
2 color change
bracket screws
color change
mount key
Figure 3 - 20
color change
bracket
color
change cam
split-hub clamp
thrust
washer
(1.00mm thick)
thrust washer
(2.75mm thick)
thrust
bearing
thrust
bearing
spacer
shaft
spacer
split-lock
clamp
pulley
Figure 3 - 21
3 - 22 Color Change
EMT 10T Technical Manual Melco Embroidery Systems