Specifications

Needle Case
Replacing Needle Bar / Presser Foot / Associated Parts
To replace a needle bar, presser foot, or other parts associated with this area refer
to the following steps:
1. Turn ON the EMT 10T and bring the head to the
HEAD UP position.
2. Turn OFF the EMT 10T and disconnect the power cord from its power source.
3. Remove the thread tensioner bracket assembly as described in a previous
procedure.
4. Remove the 2 screws holding the upper needle case cover plate and set the cover
plate aside (see Figure 3-22).
5. Loosen one and then remove the other of the 2 screws holding the lower needle
case cover plate and set the cover plate aside. You can now access the needle
bar area to remove any of the 10 needle bars out through the top of the needle
case.
6. Refer to Figure 3-23, then loosen the needle clamp set screw and remove the
needle, needle clamp, and needle clamp damper from the bottom of the needle
bar.
upper needle case
cover screws
lower needle
case cover
screws
Figure 3 - 22
3 - 24 Needle Case
EMT 10T Technical Manual Melco Embroidery Systems