manual

17
PROGRAMMING USING THE BRAND CODE
FITTING THE BATTERIES
Before programming and using the remote control,
fit the batteries.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 3, entering the code
previously used (e.g. 0025).
The TV - STB keys can be programmed according to your requirements, following the procedure described
below.
The quickest and easiest way to programme the remote control is
by consulting the website www.meliconi.com/guide.
Warning: programme one appliance at a time!
• Change the batteries if the light indicator starts to flash
during use. The batteries are low.
• Make a note of the codes for your appliances on the
adhesive label inside the battery cover in case you have
to reprogramme your remote control.
• This remote control has a permanent memory and does
not lose the programmed codes or functions when the
batteries are removed.
The remote control requires 2 new AAA/LR03 batteries. Insert the batteries as shown:
1. Switch ON the appliance you wish to program and select
a program.
2. Search for the brand of your appliance in the list of brands
at the end of this booklet. Record the code indicated
alongside (
e.g. PHILIPS 0025 ). Warning: if the brand is
not shown in the list then programming can be per-
formed using the code 0099.
3. Hold down the selection key for the appliance to be
programmed for 5 seconds.
4. When the key is released, it will start to flash. Enter the
brand code previously identified within 15 seconds (
e.g.
0025 ).The selection key flashes more quickly to indicate
that the remote control is ready for the search.
5. Point the remote control towards the appliance. Press
and slowly release the ON/OFF key several times, stopping
when the appliance responds correctly to the command.
6. When the appliance responds correctly, press the OK key
to confirm.Three flashes indicate that the search operation
has been completed correctly.
PHILIPS 0025
5 SEC.
or