Operation Manual

The functions Mute , Vol - , Vol + and AV are memorized on the keys F1 , F2 , F3 , F4 . These functions
can be used to control appliances other than the TV. For further information consult the enclosed CD or
the on-line guide on the site www.meliconi.com/guide.
CURRENT CODE DISPLAY
N.B. this operation cannot be interrupted and the remote control cannot
therefore be used until the end of the 4 series of flashes.
1. Hold down the selection key of the appliance whose code
you want to know for 5 seconds.
2.
When the key is released it will start to flash; press and
release the 1-/-- key within 8 seconds .
3. After a few seconds, the light indicator communicates
the code you are looking for by flashing the four numbers
separately. Count the number of flashes; each series of
flashes corresponds to one figure in the code. 10 flashes
correspond to 0.
4. Make a note of the code on the adhesive label inside
the battery cover for quick and easy future reprogram-
ming.
To find out the code of your remote control, follow this procedure:
Find them on your
UNIVERSAL 5-500 remote control by pressing the keys one by one and discovering the
commands that interest you.
In particular, the additional functions most frequently used, such as NORMALIZATION, COLOUR and
BRIGHTNESS, can be found on the following keys:
Although not indicated on the keypad,
some keys can be used for additional commands.
HOW TO USE THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
For the functions used less frequently, look for the additional commands on the enclosed CD or the site
www.meliconi.com/guide. As well as easily finding the code to programme your remote control, consult
the on-line guide to help you to find which keys on the UNIVERSAL 5-500 remote control correspond
to the additional commands.
You can memorize the additional commands on the function keys F1 - F2 - F3 - F4 .
5 SEC.
or
Normalization:
Brightness (+): or
Brightness (-): or
Colour (+): or
Colour (-): or
4
TV FUNCTIONS ALWAYS ACTIVE
If you know the exact code with which to programme the remote control, enter it as follows:
ENTERING THE CODE
1. Hold down the selection key for the appliance to be
programmed for 5 seconds.
2. When released, the selected key will start to flash, enter
the code (
e.g. TV 1100 ). Three flashes indicate that the
operation has been completed correctly.
5 SEC.
or
+++
11
...................................................... = 1
.......................................... = 3
= 0
....................... = 6
Code obtained = 1306
or or or
or or or