Operation Manual

ManualsBrandsMeliconi ManualsRemote ControlPratico 2

Thank you for choosing a Meliconi remote control.

Keep this booklet for future reference.

The Pratico 2 remote control is ideal for replacing up to 2 remote controls for TV - SAT (satellite decoder) - TER

(Digital Terrestrial decoder). It can also be connected to a PC using the Meliconi audio cable (to be purchased

separately), thereby allowing the user to download the most up-to-date conﬁ guration information. The remote

control has a non-volatile memory, meaning that it does not lose its settings even if there are no batteries in it.

IMPORTANT: The remote control must not be exposed to excessive heat sources.

USE OF THE BUTTONS AND FUNCTIONS

The functions of the buttons described below are available only if they exist on your device.

ON / OFF switches the device OFF and

in some cases ON

Buttons for selecting the device to

be controlled

Numeric keypad

Selects digital TV and radio

Volume control +/–

For selecting an

external input source

Conﬁ rm selection

For selecting the next programme

P+ or the previous programme P–

Fastext functions or for selecting sub-menus

using colours

TELETEXT buttons

Speciﬁ c buttons for decoder

For moving around within the MENU

MUTE turns sound OFF and ON

Selects

analogue/digital

Displays the list of programmes

Summary of content (5 pages)

PAGE 1
EN I Thank you for choosing a Meliconi remote control. Keep this booklet for future reference. The Pratico 2 remote control is ideal for replacing up to 2 remote controls for TV - SAT (satellite decoder) - TER (Digital Terrestrial decoder). It can also be connected to a PC using the Meliconi audio cable (to be purchased separately), thereby allowing the user to download the most up-to-date configuration information.
PAGE 2
Before using the remote control, insert the batteries and programme it. INSERTING THE BATTERIES The remote control requires 2 new 1.5V alkaline AA/LR06 batteries. Insert them as illustrated. Try pressing a number button and check that the red light remains lit continuously until you release the button. If the light flashes, the batteries inserted are not charged and are about to go flat, therefore you must substitute them.
PAGE 3
When the device reacts check whether the other buttons are operating correctly too. If they do, the remote control is ready to use. If they don’t, you are probably using an incorrect code destined for a very similar device; at this point ignore the SMS list and consult the SETTING CODES USING A MANUAL CODE section to find a more suitable code. NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it means the system has not been able to process the data you have sent.
PAGE 4
ENTERING THE CODE DIRECTLY (only to be performed if you know the specific code to be set) 1. Press and hold down for 6 seconds the device selection button corresponding to the device you wish to enter the code for. or 6 SEC. 2. Release the button. The indicator light will flash. Immediately enter the specific code previously found. (e.g. 1306) 3. Three long flashes indicate a correct setting. If they do not appear, repeat the procedure.
PAGE 5
TROUBLESHOOTING PROBLEM The device does not respond and the indicator light does not come on when a button is pressed. SOLUTION Check that the batteries are charged and inserted correctly and if necessary replace them with 2 new 1.5 V AA/LR06 alkaline batteries. The device does not respond but the indicator light comes on. Make sure that the remote control is pointing at the device and that there are no obstacles in the way.