Operation Manual

ManualsBrandsMeliconi ManualsRemote ControlSPEEDY 2 COMBO

This universal remote control has the essential functions for the simplified use of an analogue or a digital

television combined with a satellite or terrestrial decoder - without having to switch between one appliance and

another. The dark blue buttons transmit the commands to the decoder while the light blue buttons control the

functions that correspond to the TV. If used with a digital TV, all the buttons control the same appliance.

BUTTON AND FUNCTION USE

FITTING THE BATTERIES

Before programming and using the remote control, fit the batteries.

The remote control requires 2 new 1.5 V AAA/LR03 alkaline batteries. Insert the batteries as shown:

• The batteries must be changed once a year.

• Replace the batteries if the indicator light on the remote control starts to

flash during use. The batteries are low.

• This remote control has a permanent memory and does not lose the

programmed codes when the batteries are removed.

• Make a note of the code for your appliances on the adhesive label found

inside the battery cover. This note will be handy if you have to reprogram

your remote control.

Warning: do not expose the remote control to sources of excessive heat

Keep your Instructions Booklet for future reference.

To select the next programme.

Interrupts and restores the TV audio.

To reduce the TV's audio volume.

Numeric keypad.

Indicator light.

Button to exit the Teletext

and return to normal viewing.

TV ON button which is occasionally

needed to turn the TV on

To increase the TV's audio volume.

To select an external input

terminal to the TV.

Button to access the Teletext.

To select the previous programme.

ON/OFF to turn OFF the TV

and in some cases to turn it ON.

Thank you for choosing MELICONI.

OFF to turn the decoder off (STB).

Summary of content (4 pages)

PAGE 1
GB Thank you for choosing MELICONI. This universal remote control has the essential functions for the simplified use of an analogue or a digital television combined with a satellite or terrestrial decoder - without having to switch between one appliance and another. The dark blue buttons transmit the commands to the decoder while the light blue buttons control the functions that correspond to the TV. If used with a digital TV, all the buttons control the same appliance.
PAGE 2
PREPARE FOR USE Read these instructions carefully before programming your remote control! To command your appliances, you must programme your Speedy 2 COMBO as described in the next paragraph. For those who can connect to the internet website www.meliconi.com, you will find interactive instructions for a faster and easier programming of your remote control. HOW TO PROGRAMME THE REMOTE CONTROL If you have an analogue TV and an external decoder, follow procedure A and then procedure B.
PAGE 3
Identify and take note of the code which you have discovered following the code noting procedure (see “PROGRAMMED CODE NOTING” section). NOTE: The indicator light flashes more quickly during the search operation. The indicator light stops flashing and the remote control exits the programming mode in the following cases: • if no buttons are pressed for 12 seconds • if the end of the code search list has been reached. In this case, consult the website www.meliconi.com.
PAGE 4
TROUBLESHOOTING PROBLEM The appliance does not respond and the indicator light does not light up when a button is pressed. SOLUTION Check that the batteries are fitted correctly. If necessary, replace them with 2 new 1.5 V AAA/LR03 alkaline batteries.. The appliance does not respond but the indicator light lights up. Check that the batteries are new and that the remote control is pointing at the appliance without any obstacles in the way.