Operation Manual

INSTRUCTIONS FOR USE
Before using for the first time, run for a few
minutes without bread. Some smoke may appear
at first, this is normal and will disappear after a
short while.
- Plug into a power outlet and turn the power
outlet to on position.
- Place the bread in the openings. Adjust the
selector knob to your desired toast colour
position. Turn the selector knob to the right
between 1 and 6. The browning level will
increase in relation to the numbers. Push
down the carriage. Be aware that the
carriage will not latch down unless the plug
is in the power outlet and turned on.
- When the toasting is done, the carriage
returns to its initial position and the toast will
appear at the openings. The toaster
automatically switches off. If the bread
becomes stuck inside the toaster, switch it
off and unplug, allow cooling and remove the
bread.
- Do not use the toaster if the crumb-tray is
not in its correct position.
Use of Cancel button
When pressing the Cancel button, the automatic
cycle stops and ejects the bread. You can
interrupt the toasting process by pressing the
cancel button. The toaster is ready for immediate
re-use.
Use of Defrost button
To toast frozen bread, you do not have to adjust
the browning control. Place the bread in the bread
slots as usual ,depress the bread carriage lever
and press the defrost button. The toaster will
automatically toast for an extended period of
time.
Use of Re-heat button
If your toast has popped up and gone cold, the
toaster offers a re-heat facility. To use it, depress
the bread carriage lever and press the re-heat
button immediately, The toaster will operate for a
short period, re-heating the bread.
CLEANING
- Ensure that the toaster is unplugged before
cleaning.
- Never place in water or any other liquid.
- Before cleaning, unplug and allow to cool,
then remove the crumb-tray by pulling it
outward.
- Clean off remains of bread, burns, etc.
- Never insert any object, even a cloth, into the
toaster.
- Once the crumbs have been removed, refit
the tray, ensuring that it is in the correct
position.
14
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363 13-amp plug. If
you have to replace the fuse, only those that are
ASTA or BSI approved to BS1362 and with a rated
current of 13 amps should be used. If there is a fuse
cover fitted, this cover must be refitted after
changing the fuse.
If the fuse cover is lost or damaged, the plug must
not be used. You must also check if the socket
outlets in your home fit with the plug of the
appliance. If the socket outlet in your home does
not fit with the plug, the plug must be removed and
disposed of safely as insertion of the plug into the
socket is likely to cause electric hazard. A replace-
ment plug should be wired according to following
description.
Important
This appliance must be earthed. The wires in the
cord set are coloured
thus:
BLUE- Neutral, Brown-Live, Green& Yellow-
earth
(For detachable plug only)
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire that is coloured Green& Yellow must be
connected to the terminal in the plug that is marked
The wire that is coloured blue must be connected to
the terminal that is marked with the letter N or
coloured black.
The wire that is couloured brown must be
connected to the terminal that is marked with the
letter L or coloured red.
- If the bread gets stuck in the toaster, remove
the plug from the power outlet and let the
toaster cool off.
- Move the carriage up and down a couple of
times to release the bread. Do never use
metal objects to remove the bread.