Hot Beverage Maker User Manual

PRODUCT DESCRIPTION:
1. Spout
2. Lid
3. Water meter
4. Control lamp
5. On/Off button
6. Contact
7. Base
8. Switch for keep warm function
INSTRUCTIONS FOR USE:
1. Before first use, fill the kettle with clean
water to maximum capacity and boil.
Discard the water and repeat.
2. The kettle should always be unplugged
when filling or adding water.
3. Fill the kettle with water to the desired
level. Do not overfill or there will be a risk
of spillage or spitting. The water level
indicator will assist you to measure
correct amount. You can fill the kettle via
the spout or after opening the lid. Do not
forget to close the lid after filling
otherwise the kettle will not
automatically switch off after use.
4. Do not fill with less that 0,35 litre of
water.
5. Do not fill with more than 1,7 litres of
water (up to "MAX" indication).
6. An automatic safety cut-out has been
fitted for protection against overheating.
It will operate if the kettle is switched on
when containing insufficient water.
7. If the automatic safety cut-out has
operated, switch the kettle off,
disconnect from the power outlet and
allow the kettle to cool down for 5- 10
minutes. Then refill with water and
switch on - the kettle wills then boil and
cut off as in normal operation.
8. The kettle may be switched off at any
time by either pushing the switch of the
kettle to the "up" position or by
switching the power off at the power
outlet.
9. To pour water, lift the kettle from the
power base and pour
CORDLESS KETTLE:
1. Place the power base on a dry, flat
surface.
2. Place the kettle on the power base. The
electrical connections will be made
automatically as the kettle slides onto
the power base.
3. Plug the cord into an eathed power
socket and switch on by depressing the
switch of the kettle to the "down"
position.
4. When the water has boiled, the kettle will
switch off automatically. After allowing
the kettle to cool down for 15-20
seconds, the water can be brought back
to the boil by pushing the switch back to
the "down" position. During the cooling
down time do not force the on/off switch
into the "down" ("ON") position as this
can damage the operating mechanism.
5. Do not remove the kettle from the
power-base without first switching off.
6. Remember, if you do not wish to re-boil
the kettle, turn it off at power point.
7. The kettle may be switched off at any
time by either pushing the switch of the
kettle to the "up" position or by
switching the power off at the power
outlet.
15
1.
2.
3.
4.
5.
6.
8.
7.
645078_IM 25/07/05 9:25 Side 15