User`s guide

Install Light Unit
Main Unit Installation
MOUNT ON HELMET
2
1
Snap light unit plug and extension cable socket together securely.
Put Battery Pack in backpack or in a pack.
Adjust beam angle properly.
Snap extension cable plug and battery socket together securely.
Topeak Air BackPack
Art No. TABP-1M
3
4
Make sure the connecting
plug has been plugged in
socket completely.
WARNING
Use 3mm Allen key to
adjust and tighten.
G
B
6
3mm Allen Key
Use to fix extension cable.
Helmet Band
3mm Allen Key
2mm Allen Key
BEAM ANGLE ADJUSTMENT
Switch on light in darkened conditions on a flat surface and adjust
the beam angle vertically to desired position. It can also be pivoted
15˚ laterally. To adjust beam, loosen the adjusting bolt. Position light
unit to reach the desired beam angle and re- tighten the bolt securely.
In addition to its high brightness, the beam is
widely diffused. If you use this light on public
roads, be sure to adjust the angle downward
so as not to blind oncoming traffic.
Before removing light cap
mounting screws, make sure
bulb and light body are cool.
WARNING
LIGHT BODY MAINTENANCE
Note:
If the light body or parts become dirty, gently
clean with a soft towel using mild soap and
water. Never use harsh chemicals to clean
the lighting system as damage to housings
will occur.
BATTERY PACK CHARGING
Be sure battery charger input voltage is correct.
Connect power cord to battery charger and battery charger
plug to battery pack before connecting to home power outlet.
The battery charger LED will be RED during charging.
The battery charger LED will turn GREEN when battery is fully
charged.
The battery charger LED will not illuminate if the charger is faulty.
Disconnect the battery charger power cable from home power
outlet when the battery is removed.
It is normal for the battery charger and battery to become hot
during charging. Please use caution when charging battery.
After battery is fully charged, unplug the battery charger.
1.
2.
3.
4.
5.
6.
7.
8.
the Home
Power Outlet
Standard charging time
5 - 6 hours
Loosen the screws on both sides.
Remove the light cap.
G
B
7
Note:
If the light fails to turn on after several tries, charge the battery to full
capacity.
The standard charging time is 5 to 6 hours.
(The charging time and operating time may vary depending on ambient
temperature.)
Li-ion batteries may take 3 to 5 charging cycles to attain full capacity.
If the battery does not give the proper run time after being fully charged,
replace with a new battery pack.
Do not place battery charger in a damp or dusty
location or areas affected by oil fumes or steam.
Do not open battery charger case.
Battery charger is for indoor use only.
Avoid electrical shock.
Do not leave battery connected to charger over
48 hours continuously.
Never remove lens screws.
WARNING
Use 3mm Allen key to
adjust and tighten.