Use and Care Manual

cover the bottom of kettle completely. Leave
the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then fill
the kettle with clean water, boiling and then
discard the water. Repeat several times until
the odor of vinegar has been flushes away.
Any stains remaining inside the spout can be
removed by rubbing with a damp cloth.
LIMITED WARRANTY
In addition to the legal warranty claims, to which
the end user is entitled relative to the seller, for
this device, if it was purchased from a dealer
authorized by Wabilogic Inc. due to his
consulting competence, we grant a
manufacturer’s warranty under the following
conditions.
● 1 year limited warranty from the date of
original purchase.
● This warranty extends only to the original
retail purchaser or gift recipient. Keep the
original sales receipt, as proof of purchase is
required to make a warranty claim.
● Defects that occur due to improper
connection, improper handling or repair
attempts by non-authorized persons are not
covered by the warranty. The same applies
for failure to comply with the use of
consumables (e.g. cleaning and descaling
agents) that do not correspond to the original
specifications. Wear parts (e.g. seals and
valves) and fragile parts are excluded from
the warranty.
● This device was designed and built for
household use only. It is not suited for
other uses.
● Warranty does not cover damages that are
not the responsibility of the manufacturer.
This is valid especially for claims arising from
improper use (e.g. operation with insufficient
current or improper voltage).
4. Lift the kettle from the power base and then
pour the water.
NOTE: operate carefully when pouring the
water from your kettle as boiling water may
result in scald, besides, don’t open the lid
while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is
pressed again. The kettle may be stored on
the power base when not in use.
NOTE: Always disconnect the power supply
when not use.
BOIL-DRY PROTECT
Should you accidentally let the kettle operate
without water, the boil-dry protection will
automatically switch off the power. If this
occurs, allow the kettle to cool before filling
with cold water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power
outlet before cleaning.
● Never immerse the kettle, power cord or
power base in water, or allow moisture to
contact with these parts.
● Wipe the appearance of body with
a damp cloth or cleaner, never use
a poisonous cleaner.
CAUTION: Do not use chemical, steel, wooden
or abrasive cleaners to clean the outside of the
kettle to prevent the gloss loss.
● When not use or storage, the power cord may
be wound under the bottom of kettle.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as
the mineral deposits in tap water may form scale
on the bottom of kettle so as to cause the
operation less efficiency. You can use the
commercially available descaling agents and
follow the instructions on the package of
descaling agents. Alternatively, you may follow
below instructions using the white vinegar.
1. Fill the kettle with 3 cups of white vinegar,
thenadding water to the amount so as to
cleaning. Allow the kettle to cool
before putting on or taking off parts,
and before cleaning the appliance.
● To disconnect, turn any control
to “off,” then remove plug from
wall outlet.
● If the supply cord is damaged, it
must be replaced by the
manufacturer or its service agent or
a similarly qualified person in order
to avoid a hazard.
● Do not use the appliance for other
than intended use.
● The kettle can only use with the
power base provided.
● If the kettle is overfilled, boiling
water may spill out.
● Always ensure the lid is closed
and do not lift it while the water
is boiling. Scalding may occur if
the lid is removed during the
brewing cycles.
● This appliance is intended to be
used in household and similar
applications such as:
- Staff kitchen areas in shops,
offices and other working
environments;
- Farm houses;
- By clients in hotels, motels
and other residential type
environments;
- Bed and breakfast type
environments.
● Do not use the kettle for any
purpose other than heating water.
SAVE THESE INSTRUCTIONS
EXTENSION CORDS
● A short power-supply cord (or detachable
power-supply cord) is provided to reduce
risks resulting from becoming entangled in or
tripping over a longer cord.
● Longer detachable power-supply cords or
extension cords are available and may be
used if care is exercised in their use.
● If a long detachable power-supply cord or
extension cord is used:
1) The marked electrical rating of the
detachable power-supply cord or extension
cord should be at least as great as the
electrical rating of the appliance;
2) If the appliance is of the grounded type, the
extension cord should be a ungrounded
type 3-wire cord; and
3) The longer cord should be arranged so that
it will not drape over the counter top or
tabletop where it can be pulled on by
children or tripped over.
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is
recommended that you should clean your kettle
before use by boiling a full kettle of water twice
and then discarding the water. Wipe the surface
with a damp cloth.
OPERATION OF YOUR KETTLE
1. To fill water into the kettle, remove it from the
power base and open the lid, fill with the
desired amount of water to the kettle.
Always fill the kettle between the minimum
and maximum marks. Too little water will
result in the kettle switching off before the
water has boiled.
NOTE: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into power outlet. Turn on
the switch by pressing it, the indicator will
light up.
Then start to boil the water, the kettle will
switch off automatically once the water has
boiled. You can shut off the power by turning
off the switch at any moment during boiling
water. If you want to boil water again, only
turn on the switch directly to restart the kettle.
NOTE: Ensure that switch is free of obstructions
and the lid is firmly closed, the kettle will not
turn off if the switch is constrained or if the
lid is open.
cleaning. Allow the kettle to cool
before putting on or taking off parts,
and before cleaning the appliance.
● To disconnect, turn any control
ove plug from
wall outlet.
● If the supply cord is damaged, it
must be replaced by the
manufacturer or its service agent or
a similarly qualified person in order
to avoid a hazard.
● Do not use the appliance for other
than intended use.
● The kettle can only use with the
power base provided.
● If the kettle is overfilled, boiling
water may spill out.
● Always ensure the lid is closed
and do not lift it while the water
is boiling. Scalding may occur if
the lid is removed during the
brewing cycles.
● This appliance is intended to be
used in household and similar
applications such as:
- Staff kitchen areas in shops,
offices and other working
environments;
- Farm houses;
- By clients in hotels, motels
and other residential type
environments;
- Bed and breakfast type
environments.
● Do not use the kettle for any
purpose other than heating water.
SAVE THESE INSTRUCTIONS
EXTENSION CORDS
● A short power-supply cord (or detachable
power-supply cord) is provided to reduce
risks resulting from becoming entangled in or
tripping over a longer cord.
● Longer detachable power-supply cords or
extension cords are available and may be
used if care is exercised in their use.
● If a long detachable power-supply cord or
extension cord is used:
1) The marked electrical rating of the
detachable power-supply cord or extension
cord should be at least as great as the
electrical rating of the appliance;
2) If the appliance is of the ungrounded type, the
extension cord should be a ungrounded
type 3-wire cord; and
3) The longer cord should be arranged so that
it will not drape over the counter top or
tabletop where it can be pulled on by
children or tripped over.
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is
recommended that you should clean your kettle
before use by boiling a full kettle of water twice
and then discarding the water. Wipe the surface
with a damp cloth.
OPERATION OF YOUR KETTLE
1. To fill water into the kettle, remove it from the
power base and open the lid, fill with the
desired amount of water to the kettle.
Always fill the kettle between the minimum
and maximum marks. Too little water will
result in the kettle switching off before the
water has boiled.
NOTE: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
2. Position the kettle on the power base.
3. Connect the plug into power outlet. Turn on
the switch by pressing it, the indicator will
light up.
Then start to boil the water, the kettle will
switch off automatically once the water has
boiled. You can shut off the power by turning
off the switch at any moment during boiling
water. If you want to boil water again, only
turn on the switch directly to restart the kettle.
NOTE: Ensure that switch is free of obstructions
and the lid is firmly closed, the kettle will not
turn off if the switch is constrained or if the
lid is open.
EN