User manual

ConnectX®-3 Ethernet Single and Dual QSFP+ Port Adapter Card User Manual Rev 1.7

Mellanox Technologies

C.3 Installing the New Bracket

1. Remove the paper to expose the adhesive on the gasket.

2. Place the gasket for each port onto the new bracket. Ma

ke sure to correctly align the gasket

with the hole in the bracket.

3. If the old gaskets are still on the card, remove them before installing the new bracket. Make

sure th

at only one gasket per port is used.

Figure 15:

Gasket

Gasket Location on Adapter Card

Figure 16: Gasket Installation

1. Place the bracket onto the card until the screw holes line up.

Do not force the bracket onto the card. You may have to gently push the LEDs using a

small screwdriver to align the LEDs with the holes in the bracket.

2. Screw on the bracket using the screws and washers saved from the procedure above step 1.