User`s manual

32
Rev 1.3
Mellanox Technologies
Figure 11: Adapter card With Bracket Removed
C.1.2 Installing the New Bracket
4. Place the bracket over the connector cages and push the bracket onto the card until the screw holes line up.
Figure 12: Placing the Bracket
Note: Do not force the bracket onto the card. You may have to gently push the LEDs using a small screw-
driver to align the LEDs with the holes in the bracket.
5. Take the screws and washers saved from Step 1. Place the screws and washers into the holes and screw them in
snug.
Figure 13: Placing the Bracket on the Card
6. Make sure that the LEDs are aligned onto the bracket holes.
7. Use a torque driver to apply up to 2 lbs-in torque on the screws.