User manual

SwitchX®-2 12 Port Ethernet Switch System Hardware User Manual Rev 1.0
Mellanox Technologies
31
3. Connect the power cord.
4. Connect the data transfer cables.
3.3.2 Installation Procedure for a Side by Side Installation
No installation kit comes with this switch. The installation kit must be ordered separately. The
order number is MSX60-DKIT.
Installation kit parts for a side by side installation:
The installation kits come with enough switch mounted rails and flat head screws to install two
switches.
The 2 switch frame will fit into racks with from 21” (533mm) to 34” (864mm) between the verti-
cal supports.
Figure 18: Installation Kit Parts for a Side by Side Installation
 Installing the switch slides on the switch
1. Place the ESD mat on the floor where you will be working and put on the ESD strap. Make
sure the ESD strap is touching your skin and that the other end is connected to a verified
ground.
2. Screw the two switch mounted rails to the switch using six flat head screws per rail.
• 1 Two switch metal frame • 2 frame rail slides
• 4 switch mounting rails - The kit contains
enough rails to install 2 switches.
• 10 M-5 Pan head screws
• 24 flat head screws - The kit contains
enough screws to install 2 switches.
• 1 blank cover
• 10 spacer bushing for frame installation • 4 rubber stick-on feet 
Not used for side by side installation