User manual

SwitchX®-2 12 Port Ethernet Switch System Hardware User Manual Rev 1.0
Mellanox Technologies
35
Figure 24: Insert Switch into Frame
6. Tighten the capture nuts.
7. Install the blank panel into the frame opposite the switch, or install a second switch.
8. Tighten the capture nuts.
9. Tighten all ten screws to 9.2 Nm or 81.5 pound inches.
10.Ground the switch.
11. Plug in the power cables. Wait at least 2 seconds between inserting the first power supply
cord and inserting the second power supply cord.
12.You can start connecting all of the cables to the switch.
Wait at least 2 seconds between inserting the first power supply cord and
inserting the second power supply cord.
Anytime the switch is powered down (by choice or by power failure) you must unplug
the 2 PSUs before powering up the system.