User manual

SwitchX®-2 12 Port Ethernet Switch System Hardware User Manual Rev 1.0
Mellanox Technologies
39
The table below shows an example of static IP configuration for mgmt0 interface.
Table 13 - Configuration Wizard Session - DHCP Configuration (Example)
Wizard Session Display Comments
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes
You must perform this configuration the first time you
operate the switch or after resetting the switch. Type ‘y’
and then press <Enter>.
Step 1: Hostname? [switch] If you wish to accept the default hostname, then press
<Enter>. Otherwise, type a different hostname and press
<Enter>.
Step 2: Use DHCP on mgmt0
interface? [no] yes
Perform this step to obtain an IP address for the switch.
(mgmt0 is the management port of the switch.)
If you wish the DHCP server to assign the IP address,
type ‘yes’ and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked
whether you wish to use the ‘zeroconf’ configuration or
not.
If you enter ‘no’ (no Zeroconf), then you need to enter a
static IP, and the session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6
addresses.
Step 4: Enable IPv6 auto-config
(SLAAC) on mgmt0 interface?
[no]
This turns on auto-configuration of the IPv6 addresses.
This is unsuitable for DHCPv6.
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
To enable DHCPv6 on the MGMT0 interface.
Step 6: Admin password (Press
<Enter> to leave unchanged)?
<new_password>
Step 6: Confirm admin pass-
word? <new_password>
To avoid illegal access to the machine, please type a pass-
word and then press <Enter>. Then confirm the password
by re-entering it.
Note that password characters are not printed.
You have entered the following
information:
<A summary of the configura-
tion is now displayed.>
To change an answer, enter the
step number to return to or hit
<enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
The wizard displays a summary of your choices and then
asks you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the
configuration step number that you wish to return to.
Note:
To re-run the configuration wizard run the command
“configuration jump-start” in Config mode.