User Manual

8 D30396 | Date 09/2014
AtmoCONTROL FDA Version
2) If one or several of the above terms should be or become invalid, this does not affect the
effectiveness of the other terms. The invalid term is to be replaced by a valid term which as far
as possible realizes the intended commercial purpose This also applies in case of a gap in the
agreement.
3) This agreement is subject to the law of the German Republic. Legal domicile is the domicile
of the licensor. All questions relating to the validity, interpretation and performance of the
contents of this agreement should be clarified at the legal domicile of the licensor in the Ger-
man Republic.
2.
Introduction
2.1
Description
AtmoCONTROL is a software for programming and logging MEMMERT appliances of the
generation 2012 of appliances (from October 2012) with Ethernet and/or
USB interface and
corresponding equipment.
With AtmoCONTROL, you can
►
graphically create, modify and save programmes on your computer with various param-
eters and transfer these to the appliance (description from page 16);
►
read out, organise and document the internal log memory of appliances (description from
page 30);
►
configure user authorisations on USER ID USB sticks, with which the manual adjustment
of individual or all parameters on the appliance can be prevented (description from page
31).
2.2
Supported MEMMERT appliances and parameters
Using AtmoCONTROL, programmes can be created and transferred, protocols read out, USER
IDs configured and FDA functions executed for the following appliances of the generation
2012 of appliances (as of October 2012):
Appli-
ance
Programmable main parameter
Temperature Humidity Pressure CO
2
Fan speed Air fl ap Light*
UN
PLUS

–
–
–
–


UF
PLUS

–
–
–



IN
PLUS

–
–
–
–


IF
PLUS

–
–
–



SN
PLUS

–
–
–
–


SF
PLUS

–
–
–



HPP


–
–
–
–

IPP
PLUS

–
–
–
–
–

ICP

–
–
–

–

ICH


–

*

–

* additional option
For all other MEMMERT appliances of the generation 2012 of appliances, protocols can only
be read out using AtmoCONTROL via Ethernet (see page 30); parameters can only be set on
the appliance itself, and FDA functions are not available.
the appliance itself, and FDA functions are not available.