Manual

34
Operation and Control
By turning further to the right, parameters (temperature, humidity setpoints etc.) can be
selected as in the normal operating mode.
If no settings (temperature setpoint etc.) are made for the ON phase, the controller takes
over the values from the normal operating mode.
For reasons of safety, you should always check that a switch-on time is only programmed in
the desired time blocks and days.
If the controller is in standby mode or the week time switch is in the ON phase, the tempera-
ture setpoint can be directly accessed by briefly pressing the SET key. By turning the control
to the right, you get to the temperature monitoring, humidity and CO
2
settings. By turning to
the left, you can return to the settings for the individual time blocks.
5.10.4
Settings example week time switch
The appliance should switch on from Mo-Fr (workdays group) at 9.30 (am) and switch off at
19.00 (7pm). In addition, it should operate on Saturday from 10.00 (am) to 14.00 (2pm) (see
Fig. 18
).
Mo
Sa
Fr
Th
We
Tu
Su
Fig. 18
Operation with week time switch (example)
1.
Setting the week time switch operating mode
Hold the SET key down for approx. 3 seconds and the
current operating mode then begins to flash. Select the
week time switch operating mode
with the push-
with the push-
turn control, while the SET key is held down.
Release the SET key and the control is now in the week
time switch operating mode.
PRINT
SETUP