Operating instructions

PERFECT
loop
t1
t2
t3
t4
loop
t1
t2
t3
t4
page 12
6 Selecting the operating mode
PRINT
SETUP
After holding down the SET key (approx. 3 sec), the current operating mode flashes on the display. A
different operating mode can be selected with the push/turn control while the SET key is being held down.
After the SET key has been released the controller operates in the new operating mode.
7 Setting the parameters
After an operating mode has been selected, all relevant controller settings are shown simultaneously on
the display.
A parameter (menu item) can be selected by rotating the push/turn control; all other parameters are then
dimmed.
The selected parameter flashes brightly and can now be altered with the push/turn control while holding
down the SET key.
After the SET key has been released the newly set value is stored.
If the push/turn control or the SET key have not been operated for a period of 30 seconds, the controller
automatically returns to the main menu.
Interior lighting (option)
Turn the push/turn control anticlockwise until the light symbol is flashing.
While holding down the SET key, use the push/turn control to set the light on or off.
When operating in the “weekly programmer” mode the internal illumination is switched off automatically
when the equipment is switched off by the weekly programmer.
Normal
operation
Weekly
programmer
Programme
operation
Printer Basic settings