Install guide

15
CSEL
SLAVE
MASTER
IDE
INTERFACE
CONNECTOR
DC INPUT
1
+
5V
G
+
12
V
TTopopTop
Bottom
4-pin power cable
AUDIO OUT
DIGITAL ANALOG
D G
R G L
17. Carefully slide your new drive into the bay. Locate the screw holes on the drive and
match them against the screw holes in the chassis. Insert all 4, 3mm mounting screws
from the sides and tighten them. Be careful not to drop any of the screws inside the
computer. Do not over tighten screws; this may cause drive mechnism to jam or the
screw to break off.
18. Visually inspect your computer and make sure that you have not pulled any other
cables loose, that no cables may be pinched when the case is re-installed, and that
no wires are obstructing any cooling fans or block ventilation.
19. Put the cover of your computer back on its chassis and fasten it properly.
20. Reconnect the computer to the AC outlet and power it up.