Mi3005 Suffix A User’s Guide iMove with AM/FM Radio Before operating this product, please read these instructions completely.
SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
SAFETY PRECAUTIONS INFORMATION: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
LOCATION OF CONTROLS 1. FM Antenna 2. Left Speaker 3. iPod® Dock with Connector & Interchangeable Holders 4. VOLUME Up/Down Buttons 5. Power Button 6. Display 7. MODE Button 8. Battery Compartment (Rear of Unit) 9. Carrying Handle 10.Right Speaker 11. TUNE Up/Down/Skip n / o Buttons 12.PRESET Button 13.Remote Sensor 14.SET Button 15.Headphones Jack (Rear of Unit) 16.POWER IN Jack (Rear of Unit) 17.
LOCATION OF CONTROLS (CONTINUED) REMOTE 1. Battery Compartment (Side of Unit) 2. TUNE Down/Skip o Button 3. VOLUME Down Button 4. MODE Button 5. VOLUME Up Button 6. PRESET Button 7. Power/PLAY/PAUSE (®p) Button 8. TUNE Up/Skip n Button 9. Belt Clip NOTES: To turn on the unit, press the Power/PLAY/PAUSE (®p) button; • the display will light. To turn off the unit, press and hold the Power/PLAY/PAUSE (®p) button until the unit turns off (the LCD display will turn off), then release the button.
REMOTE CONTROL REMOTE BATTERY INSTALLATION 1. 2. Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out. Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up). 3. Replace the Battery Compartment. BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Use only the size and type of battery specified. 2.
POWER SOURCE AC CONNECTION Insert the small end of the AC adapter into the POWER IN jack (located on the rear of the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet having 120V AC, 60 Hz. AC Outlet AC Plug NOTES: • Only use the supplied AC adapter which has the following specs: DC 12V Z • The AC adapter supplied with the unit is polarized to help minimize the possibility of electric shock.
2 – +– +– +– + 1 INSERTING AN IPOD® – +– +– +– + Plug the unit in or insert batteries as described on page 6. Locate the correct iPod® holder to use as shown on pages 11-12. Slide the holder downward as shown to insert. 3 4 If using the dock: With the iPod® and the Mi3005 OFF, insert the iPod® onto the holder. Gently push down so the connector on the iPod® slides onto the connector on the Mi3005.
OPERATION USING AN IPOD® WITH THIS UNIT 1 2 With an iPod® connected (see previous page), turn the Mi3005 on by pressing the Power button (if it is not on already). Operate the iPod ® as per its owner’s manual and the sound will be heard through the Mi3005’s 1 speakers. Adjust the volume as desired by pressing the Volume Up/Down buttons. 3 4 For private listening, plug in headphones into the Headphones jack on the rear of the Mi3005. The speakers will be disconnected 1 when headphones are plugged in.
OPERATION (CONTINUED) USING THE RADIO 1 2 Turn the Mi3005 on by pressing the Power button; the display will light. 3 Press the MODE button to select the desired band (AM or FM). 4 1 1 Adjust the volume as desired by pressing the Volume Up/Down buttons. For private listening, plug in headphones into the1Headphones jack on the rear of the Mi3005. The speakers will be disconnected when headphones are plugged in.
OPERATION (CONTINUED) SETTING THE RADIO PRESETS (5 EACH BAND) 1 2 1 2 Follow Steps 1-3 on the previous page to tune a station. Press the SET button “P1” (if no presets have ever been set), will blink. 1 Press the TUNE Up/Down/Skip n / o buttons 1 (or you can also press the PRESET button) to select a desired Preset (P1-P5). Press the SET button 2 again to confirm, the station will be saved into memory. Repeat to program up to 5 Presets in each band, as desired.
OPERATION (CONTINUED) IPOD® HOLDER Locate your iPod® in the chart on the next two pages and select the respective holder (the Holder No. is engraved at the top of the holders) to match with your iPod®. Insert the corresponding holder and your iPod® into the unit as described on page 7. iPod® Type Fourth Generation iPod® iPod® Photo iPod® mini 11 Memory 10 to 15GB Holder No. No. 3 30GB No. 4 30GB No. 5 40 to 60GB No. 6 4 to 6GB No.
iPod® OPERATION (CONTINUED) Type Memory iPod® nano 2 to 4GB Fifth Generation iPod® (w/Video) Holder No. No. 8 30GB No. 9 60GB No. 10 NOTE: • The 8 holders provided with this unit are for use with this unit only; they are not Universal Docks.
TROUBLESHOOTING GUIDE If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM CAUSE AM or FM, no sound. Power is not on. No sound. SOLUTION Volume is set to minimum. set to minimum. Station is not tuned mode, not charging battery. Increase volume. Retune the AM or FM broadcast station. antenna is not antenna. AM: Unit is not pos- Rotate unit until best Incorrectly connected. Check the connection. properly adjusted.
SPECIFICATIONS GENERAL: Power Source .............DC 12V (8 x 1.5V ‘D’ size batteries) ...............................Alkaline is recommended for longer life ...................................DC IN 12V Adapter (Center Positive) Speaker...............................................................2 x 4 ohms Output Power .........................................................2 x 10W RADIO SECTION: Frequency Range (FM) ................................87.5–108 MHz Frequency Range (AM) .....................
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.
