Mi1006 User’s Guide iListen with AM/FM Radio Before operating this product, please read these instructions completely.
SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
SAFETY PRECAUTIONS INFORMATION: This equipment complies with Class B digital device regulations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
MAIN UNIT LOCATION OF CONTROLS 17 18 1. Left Speaker 2. Headphones Jack (Side of Unit) 3. LINE IN Jack (Side of Unit) 4. iPod® Dock with Connector & Interchangeable Holders 5. MODE Button 6. VOLUME Up/Down Buttons 7. Power Button 8. S-Video Jack (Rear of Unit) 9. AM Loop Antenna Jack (Rear of Unit) 10.Display 11. Right Speaker 12.PRESET Button 13.TUNE Up/Down/Skip n / o Buttons 14.SET Button 15.POWER IN Jack (Rear of Unit) 16.FM Wire Antenna (Rear of Unit) 17.Remote Sensor 18.
LOCATION OF CONTROLS (CONTINUED) REMOTE 1. Battery Compartment (Side of Unit) 2. TUNE Down/Skip o Button 3. VOLUME Down Button 4. MODE Button 5. VOLUME Up Button 6. PRESET Button 7. Power/PLAY/PAUSE (®p) Button 8. TUNE Up/Skip n Button 9. Belt Clip NOTES: • The remote buttons function in the same way as the buttons on the main unit. • For the Belt Clip, simply clip it to to a non-slip location such as your belt, purse or backpack. • To turn on the unit, press the Power/PLAY/PAUSE (®p) button.
POWER SOURCE AC CONNECTION Insert the small end of the AC adapter into the POWER IN jack (located on the rear of the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet having 120V AC, 60 Hz. AC Adapter, DC 20V Z AC Outlet AC Plug NOTES: • The AC adapter supplied with the unit is polarized to help minimize the possibility of electric shock. If the AC plug does not fit into a nonpolarized AC outlet, do not file or cut the wide blade.
OPTIONAL FEATURES S-VIDEO JACK (Rear of Unit) If you are using an iPod® that has photo/video capability, and your TV has an S-Video input, you can connect the Mi1006 to the external TV with an S-Video cable. You will then be able to view the photos/videos from the iPod® on your external TV. NOTES: • Set the TV’s TV/VIDEO button or switch to the VIDEO setting. • When connecting the Mi1006, refer to the owner’s manual of the TV, as well as this manual.
1 INSERTING AN IPOD® 2 Locate the correct iPod® holder to use as shown on pages 12-13. Insert the holder into the cavity (as shown), making sure the tabs are facing front, and slip the tabs into place. Press the rear side of the holder until it is positioned inside the cavity. NOTE: To remove the holder, insert your finger (or other object) into the gap in the holder, then gently pull the holder out to remove it. 3 4 If using the dock: Insert the iPod® onto the holder.
OPERATION USING AN IPOD® WITH THIS UNIT 1 2 With an iPod® connected (see previous page), turn the Mi1006 on by pressing the Power button (if it is not on already). 1 Operate the iPod ® as per its owner’s manual and the sound will be heard through the Mi1006’s speakers. 1 1 desired by Adjust the volume as pressing the Volume Up/Down buttons.
OPERATION (CONTINUED) USING THE RADIO For FM reception, fully extend the FM Wire Antenna for best FM reception. For AM reception, there is an AM Loop Antenna included; connect the AM Loop Antenna, as shown below, before listening to the AM radio for better reception. 1 2 Extend the AM Loop Antenna wire (length is approx. 3 ft). Connect the AM Loop Antenna adapter to the AM Loop Antenna jack at the rear of the main unit. Make sure the adapter is inserted correctly into the jack, as shown.
OPERATION (CONTINUED) USING THE RADIO (Continued) 1 Turn the Mi1006 on by pressing the Power button; the display will light. 3 1 2 Press the MODE button repeatedly to select the desired band (AM or FM). 4 1 1 1 Adjust the volume as desired by pressing the Volume Up/Down buttons. For private listening, plug in headphones into the Headphones jack on the rear1of the 1 Mi1006. The speakers will be disconnected when headphones are plugged in.
OPERATION (CONTINUED) SETTING THE RADIO PRESETS (5 EACH BAND) 1 2 2 Follow Steps 1-3 on the previous page to tune a station. Press the SET button “P1” (if no presets have ever been set), will blink. 1 1 Within three seconds, press the TUNE Up/Down/Skip n / o buttons 1 (or you can also press the PRESET button) to select a desired Preset (P1-P5). Press the SET button 2 again to confirm, the station will be saved into memory. Repeat to program up to 5 Presets in each band, as desired.
OPERATION (CONTINUED) IPOD® UNIVERSAL DOCKS Locate your iPod® in the chart on the next two pages and select the respective Universal Dock (the Universal Dock No. is engraved at the front of the Universal Docks as shown on the next page) to match with your iPod®. Insert the corresponding Universal Dock and your iPod® into the unit as described on page 7. iPod® Type Fourth Generation iPod® iPod® Photo iPod® mini 12 Memory 10 to 15GB Univ. Dock No. No. 4 30GB No. 5 30GB No. 6 40 to 60GB No.
iPod® OPERATION (CONTINUED) Type Memory iPod® nano 2 to 4GB Fifth Generation iPod® (w/Video) 30GB Univ. Dock No. Please use the Universal Dock included with your iPod®. 60GB NOTE: • The 5 holders provided with this unit are Universal Docks. IMPORTANT! The Universal Dock No. is engraved at the front of the docks. Please refer to the illustration below for the location of the Universal Dock No.
TROUBLESHOOTING GUIDE If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM CAUSE AM or FM, no sound. Power is not on. No sound. SOLUTION Volume is set to minimum. set to minimum. Station is not tuned properly. then the MODE button to Increase volume. Retune the AM or FM broadcast station. FM: Wire antenna Extend FM wire AM: AM Loop antenna See page 9 to connect is not extended. iPod® mode, no sound. Press the Power button, select AM/FM.
SPECIFICATIONS GENERAL: Power Source ................DC 20V Adapter (Center Positive) Speaker.............................................................2 x 16 ohms Output Power ...........................................................2 x 6W RADIO SECTION: Frequency Range (FM) ................................87.5–108 MHz Frequency Range (AM) ...............................520–1710 KHz Specifications are subject to change without notice.
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.