MK 1700A 14 CHANNEL FAMILY RADIO SYSTEM CALL ENTER MENU MIC PW R BEFORE OPERATING THIS PRODUCT PLEASE READ THESE INSTRUCTIONS COMPLETELY
CONTENTS FCC Warmings.............................................................................1 Features........................................................................................1 Precaution.....................................................................................1 Unpacking.....................................................................................1 Controls and Indicators.................................................................2 Install Batteries..............
FCC WARNINGS This device complies with part 15 of the FCC rules, operation is subject to the condition that this device does not cause harmful interference.
Controls and Indicators 1. Earphone/Microphone jack 2. Transmission/Reception indicator 3. PTT button 4. MONITOR button 5. ENTER/LOCK button 6. UP/DOWN buttons 7. Microphone 8. POWER button 9. MENU button 10. CALL button 11. Power Saver mode 2 3 indicator 12. LED display 4 13. Ext. Power IN 5 6 7 1 CALL ENTER MENU MIC PW R 13 12 11 10 9 8 Display and Indicators LED display - indicates Channel numbers, Volume level, Lock, Beep, Low Battery Level, etc.
Operation Install Batteries 1. 2. Pull lock tab down and lift door up (towards you) to remove battery cover. batteries. Position batteries according to Insert four polarity markings. Note : When batteries are low or need charging the BATTERY LOW “L” will blink. Replace all batteries with new alkaline batteries.
To Turn On The Unit or To Turn Off The Unit Press the POWER switch for more than 1 second. Auto Battery Power Saver The unit has a special circuit designed to extend battery life. If there are no transmissions within 5 seconds, the unit will automatically switch to battery save mode. The Power Saver Mode LED(Green) will flash. Low Battery Indicator When battery level becomes low, “L” appears on the LED display and flashes. Replace all four batteries with new ones.
Automatic Channel Scan Press and hold the UP or DOWN button to search signals. When the unit catches a strong signal , scan will stop for 5 seconds. If you want to stop at that channel, press the PTT or ENTER button. To Send Call Tone Call tone sounds like a telephone ring, and is convenient for quickly identify yourself to another party. Persons whom you call will instantly recognize you because of your call tone. Press the CALL button to send Call Tone. “C” appears on the LED display and flashes.
To Turn On or Off VOX with the built-in microphone This feature enables you to disable the built-in microphone in VOX when you use the unit under noisy environment. 1. To disable the built-in microphone, press the MENU and ENTER buttons simultaneously. The LED display indicates as shown below. Disable the built-in microphone 2. To turn on the built-in microphone, press the MENU and ENTER buttons simultaneously again. The LED display indicates as shown below. The built-in microphone is turned on.
Frequency Range The FRS 80 unit represents one of the most advanced FM twoway radios used. FRS Channel Channel Frequency In MHz 1 2 3 4 5 6 7 8 9 10 11 12 13 14 462.5625 462.5875 462.6125 462.6375 462.6625 462.6875 462.7125 467.5625 467.5875 467.6125 467.6375 467.6625 467.6875 467.
General Specifications A. Frequency CH = 14 Channels within 462 -467 MHz. B. Receiver 1. Sensitivity For 12 dB signal 2. Max. audio output @ 10% THD 3. Max. S/N ratio @ 1mV RF input 4. Squelch Sens 5. Audio frequency resp. @ 300 Hz @ 3000 Hz 6. Signal displacement BW 7. Adjacent CH. rejection 8. Intermodulation rejection 9. Spurious response rejection 0.25 µV 300 mW 40 dB 0.2 µV ± 10 dB ± 10 dB ± 5 kHz 55 dB 55 dB 55 dB C. Transmitter 1. Effective radiated power 2. Carrier freq. stability 3.