MKA381 User’s Guide Wireless Microphone Before operating this product, please read these instructions completely.
SAFETY PRECAUTIONS FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
LOCATION OF CONTROLS MICROPHONE 1 RECEIVER FRONT RECEIVER REAR 4 2 3 5 7 6 8 1. POWER Indicator 2. Microphone ON/STANDBY/OFF Switch 3. Battery Compartment 4. Microphone ON Indicator 5. POWER ON Indicator 9 10 6. POWER ON/OFF Switch 7. Antenna 8. Battery Compartment (Bottom of Receiver) 9. DC 4.5V Jack 10.
INSTALLATION REPLACING THE BATTERIES If the sound quality starts to become poor or the receiving distance has shortened, replace the batteries in the microphone and the receiver as follows: INSTALLING THE BATTERY INTO THE MICROPHONE 1 2 Remove the battery cover at the bottom of the microphone by twisting it counterclockwise. Insert one 9V battery, making sure to observe the correct polarity (+/–). Twist the battery cover clockwise to put it back on.
OPERATION USING YOUR MICROPHONE (TRANSMITTING) To use your microphone, please see the following: 1 2 Insert the large end of the cord into the Microphone jack on the unit you are connecting this wireless microphone to, and the small end into the Line OUT jack on the receiver. Slide the Microphone ON/STANDBY/ OFF switch to the ON position; the POWER indicator on the microphone will light. 3 4 Slide the Receiver’s POWER switch to the ON position; the red POWER indicator on the receiver will light.
SPECIFICATIONS Power Requirement Receiver .........................DC 3V, 2 X LR6 “AA” Alkaline Battery Microphone..........................................................DC 9V Battery Frequency ..............................................................171.045MHz Receive Distance...................................................................7m Specifications subject to change without notice. FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT OUR WEBSITE AT WWW.MEMOREXELECTRONICS.
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.
