Service manual

Engine Engine Electrical 6-31
2006 LSSV Service Manual Supplement
Front Winch Harness and Connector
Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
2. Remove the positive cable (1) from the junction block (2).
3. Remove the negative cable from the engine block.
4. Remove any wiring harness straps securing the cable to
the vehicle.
5. Remove the bolts (1) from the winch connector (2).
6. Remove connector/harness from vehicle.
Note cable routing for installation.
Installation Procedure
1. Install connector/harness to the vehicle in the same
routing as removed.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Position the connector (2) on the bumper and install bolts
(1).
Tighten
Tighten the connector bolts to 10-15 N•m (7-11 lb ft).