Service manual

6-32 Engine Electrical Engine
2006 LSSV Service Manual Supplement
3. Install the negative cable to the engine and the fastening
bolt.
Tighten
Tighten the negative cable bolt to 34 N•m (25 lb ft).
4. Install the positive cable (1) to the junction block (2).
Tighten
Tighten the junction block nut to 9 N•m (80 lb in).
5. Install connector/harness to vehicle in original location
using wiring harness straps.
6. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.
Rear Winch Harness and Connector
Replacement (LSSV)
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
2. Remove the negative cable (3) from the junction block.
3. Remove the positive cable (1) from the junction block (2).
4. Remove the wiring harness straps securing the cable.
5. Remove the clamp bolt and clamp from cable.
6. Remove the bolt (1) securing cable connector to the
bracket.
7. Remove the cable (2) from the vehicle.
Note cable routing for installation.