Service manual

Engine Engine Electrical 6-33
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the cable (2) onto the vehicle in the same location
as removed.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the connector onto the bracket and secure with
bolt (1).
Tighten
Tighten the connector bolt to 10-15 N•m (7-11 lb ft).
3. Install the clamp and secure with bolt.
4. Working from the rear to the front of the vehicle install the
wiring harness straps.
5. Install the positive cable (1) to the junction block (2).
6. Install the negative cable (3) to the junction block (2).
Tighten
Tighten the junction block nuts to 34 N•m (25 lb ft).
7. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.
Slave Receptacle Harness Replacement
(LSSV)
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.
2. Trace the negative slave receptacle cable connector (2)
to the cable ground connection.
3. Disconnect the negative slave receptacle ground cable
from the ground connection.
4. Trace the positive slave receptacle cable connector (1) to
the 24V battery connection.
5. Disconnect the positive slave receptacle cable from the
24V battery connection.