Service manual

6-34 Engine Electrical Engine
2006 LSSV Service Manual Supplement
6. Disconnect the slave receptacle connectors from the
slave receptacle. Refer to Slave Receptacle
Replacement (LSSV).
7. Remove the wiring harness straps securing the slave
receptacle harness and the blackout (B/O) harness.
8. Remove the slave receptacle harness from the bumper
assembly.
Installation Procedure
Important: Verify all connections are clean prior to installation.
1. Position the slave receptacle harness onto the bumper
assembly.
2. Install the 3 clamps and the fasteners onto the slave
receptacle harness and the blackout (B/O) harness.
3. Connect the slave receptacle connectors to the slave
receptacle. Refer to Slave Receptacle Replacement
(LSSV).
4. Install the positive slave receptacle cable in the same
routing location as removed.
5. Connect the positive slave receptacle cable connector (1)
to the 24V battery connection.
6. Install the negative slave receptacle cable in the same
routing location as removed.
7. Connect the negative slave receptacle connector (2) to
the cable ground connection.
8. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.