Service manual

Engine Engine Electrical 6-35
2006 LSSV Service Manual Supplement
Slave Receptacle Replacement (LSSV)
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.
2. Unscrew the slave receptacle cover (1).
3. Remove the fasteners (2) securing the slave receptacle
to the radiator grille guard bracket.
4. Remove the slave receptacle (3).
5. Disconnect the negative cable connections (2).
6. Remove the rubber cover from the rear of the positive
cable connection.
7. Disconnect the positive cable connection (3).
8. Remove the slave receptacle and the gasket from the
bracket.
Installation Procedure
Important: The gasket must mount to the square back of the
slave start connector assembly.
1. Position the slave receptacle with the gasket onto the
bracket.
2. Install the positive cable onto the connection (3).
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the negative cable onto the connection (2).
Tighten
Tighten the connections to 20 N•m (15 lb ft).