Service manual

Body and Accessories Body Front End 8-5
2006 LSSV Service Manual Supplement
Repair Instructions
Upper Front Fender Reinforcement
Replacement
Removal Procedure
1. Open the vehicle hood.
2. Remove the upper reinforcement bolt (2).
3. Remove the fender support bolt (1).
4. Using a flat bladed tool, separate the upper
reinforcement (3) from the bonding adhesive securing it
to the fender.
5. Remove the upper reinforcement (3) from the fender.
Installation Procedure
1. Remove any old panel bonding adhesive from the fender.
2. Apply panel bonding adhesive (5) to the upper
reinforcement.
3. Install the upper reinforcement (3) onto the fender.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the fender support bolt (1).
Tighten
Tighten the bolt to 25 N•m (18 lb ft).
5. Install the upper reinforcement bolt (2).
Tighten
Tighten the bolt to 10 N•m (89 lb in).
6. Close the vehicle hood. Verify correct fender alignment.
Lower Front Fender Reinforcement
Replacement
Removal Procedure
1. Open the vehicle hood.
2. Remove the reinforcement bolt (2).
3. Remove the fender support bolt (1).
4. Using a flat bladed tool, separate the lower reinforcement
(4) from the bonding adhesive securing them to the
fender.
5. Remove the lower reinforcement (4) from the fender.