Service manual

8-6 Body Front End Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Remove any old panel bonding adhesive from the fender.
2. Apply panel bonding adhesive (5) to the lower
reinforcement.
3. Install lower reinforcement (4) onto the fender.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the fender support bolt (1).
Tighten
Tighten the bolt to 25 N•m (18 lb ft).
5. Install the reinforcement bolt (2).
Tighten
Tighten the bolt to 10 N•m (89 lb in).
6. Close the vehicle hood. Verify correct fender alignment.
Hood Bumper Replacement
Removal Procedure
1. Remove the front hood bumper by turning the front hood
bumper (1) out counterclockwise.
2. Remove the jamb nut (2) from the hood bumper by
turning counterclockwise.
Installation Procedure
1. Install the jamb nut (2) by turning clockwise onto the
hood bumper.
2. Install the front hood bumper (1) by turning the front hood
bumper in clockwise until the hood closes flush with the
fender.