Service manual

8-12 Body Rear End Body and Accessories

2006 LSSV Service Manual Supplement

Installation Procedure

1. Apply 2 sided foam tape to the underside of the rails and

to the edges of the mounting holes.

Important: Do not use the jacknuts supplied in the kit. Use

rivnuts (TX016183) instead.

2. Install the 4 rivnuts (if damaged) to the mounting holes

using a rivnut installer.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the 2 front end rails to the front end of the box with

4 bolts over the 4 rivnuts.

Tighten

Tighten the 4 bolts to 8 N•m (70 lb in).

4. Install the front of the cargo cover to the front end rail as

needed. Refer to Cargo Cover Replacement.

Cargo Cover Rear End Rail Replacement

Removal Procedure

1. Remove the cargo cover from the end gate side of the

cargo cover assembly. Refer to Cargo Cover

Replacement.

2. Remove the 4 bolts from the end gate rail as needed.

3. Remove the 4 rivnuts by drilling out (if damaged).

Installation Procedure

1. Apply 2 sided foam tape to the underside of the rail and