Service manual

Body and Accessories Bumpers 8-21
2006 LSSV Service Manual Supplement
Bumper End Cap Replacement – Front
Removal Procedure
1. Remove the center brush guard. Refer to Center
Radiator Grille Brush Guard Replacement.
2. Remove the brush guard end. Refer to Outer Radiator
Grille Brush Guard Replacement.
3. Remove the bolts (1) from the end cap brace. If the right
side is being removed the ground cable must also be
removed.
4. Remove the blackout (B/O) marker lamp. Refer to Marker
Lamp Replacement – Front Blackout (B/O) (LSSV).
5. Remove the bolts (1) from the end cap brace.
6. Remove the end cap from the vehicle.
Installation Procedure
1. Install the end cap to the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts (1) to the end cap.
Tighten
Tighten the bolts to 88-98 N•m (65-72 lb ft).