Service manual

Body and Accessories Bumpers 8-23
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the front bumper bracket onto the frame.
2. Install the side and lower bolts, do not tighten at this time.
3. Install the center bumper (4). Refer to Center Front
Bumper Replacement.
4. Install the bumper end cap (3). Refer to Bumper End Cap
Replacement – Front.
5. Install the end brush guard (1). Refer to Outer Radiator
Grille Brush Guard Replacement.
6. Install the center brush guard (2). Refer to Center
Radiator Grille Brush Guard Replacement.
7. Install the front winch connector. Refer to Front Winch
Harness and Connector Replacement in Engine
Electrical.
8. Install the front winch receiver. Refer to Front Pull Winch
Receiver Replacement in Frame and Underbody.
Notice: Refer to Fastener Notice in Cautions and Notices.
9. Align the front bumper and tighten the side frame bolts
(1) and lower frame washered bracket bolt (2).
Tighten
• Tighten side bolts to 128-148 N•m (94-109 lb ft).
• Tighten lower bolt to 68-92 N•m (50-68 lb ft).
Step Pad Replacement – Rear Bumper
Removal Procedure
1. Remove the upper mounting bolts (1).
2. Remove the lower mounting bolts (2).
3. Remove the step from the bumper.