Service manual

8-24 Bumpers Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the step onto the bumper.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the upper mounting bolts (1).
Tighten
Tighten upper bolts to 45 N•m (33 lb ft).
3. Install the lower mounting bolts (2).
Tighten
Tighten lower bolts to 45 N•m (33 lb ft).
License Plate Bracket Replacement
Removal Procedure
1. Remove the retention pin (1) and pivot the bracket down.
2. Remove the pivot bolt (2) and washer from the bracket.
3. Remove the bracket from the bumper.
4. Remove the license plate from the bracket.
Installation Procedure
1. Inspect the bracket pivot bushing and replace as needed.
2. Install the license plate on the bracket.
3. Install the bracket on the bumper and install washer and
bolt (2). Tighten the bolt until the bracket pivots open
freely.
4. Pivot the bracket into the up position and install the
retention pin (1).