Service manual

Body and Accessories Bumpers 8-27
2006 LSSV Service Manual Supplement
8. Remove the 24V trailer connector (3). Refer to Military
Trailer Connector Replacement (LSSV) in Lighting
Systems.
9. Remove the 12V trailer connector (1). Refer to
Commercial Trailer Connector Replacement (LSSV) in
Lighting Systems.
10. Remove the rear winch power disconnect (2) (if
equipped). Refer to Rear Winch Harness and Connector
Replacement (LSSV) in Engine Electrical.
11. Remove the rear relay mounting bracket from the
bumper.
12. Remove the rear lamp wiring harness. Refer to Lamp
Harness Replacement – Rear (LSSV) in Wiring Systems.
13. Remove the bolts (1) securing the bumper to the vehicle.
14. Remove the bumper and spacers from the mounting
brackets.
Installation Procedure
1. Position the bumper and spacers to the vehicle and
loosely install the bolts (1).
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Align the bumper from side to side and tighten bolts.
Tighten
Tighten bumper bolts to 97 N•m (72 lb ft).
3. Install the rear lamp wiring harness. Refer to Lamp
Harness Replacement – Rear (LSSV) in Wiring Systems.
4. Install the rear relay mounting bracket from the bumper.