Service manual

8-60 Instrument Panel, Gages, and Console Body and Accessories
2006 LSSV Service Manual Supplement
4. Disconnect the voltmeter gage bulb and harness
connectors (3) from the gage.
5. Disconnect the blackout (B/O) harness connectors (1)
from the switches.
6. Disconnect the air line (2) from the air filter restriction
gage (if equipped).
7. Remove the panel (4) from the vehicle.
8. Remove the parts from the accessory panel. Refer to
Blackout (B/O) Switch Replacement in Lighting Systems
or Voltmeter Gage Replacement or Air Filter Restriction
Gage Replacement.
Installation Procedure
1. Install the parts removed from the accessory panel. Refer
to Blackout (B/O) Switch Replacement in Lighting
Systems or Voltmeter Gage Replacement or Air Filter
Restriction Gage Replacement.
2. Install the connectors (1) to the blackout (B/O) switches.
3. Install the connector and bulb (3) to the voltmeter gage.
4. Connect the air line (2) on to the air filter restriction gage.
5. Install the accessory panel (2) onto the dash.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the fasteners (1) and tighten.
Tighten
Tighten accessory panel bolts to 8 N•m (71 lb in).