Service manual

Body and Accessories Lighting Systems 8-109
2006 LSSV Service Manual Supplement
Repair Instructions
Topper Dome Lamp Switch Replacement –
Front
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Caution
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
2. Remove the accessory panel. Refer to Accessory
Instrument Panel (I/P) Replacement in Instrument Panel,
Gages and Console.
3. Remove the nut (2) and washer (3) from the switch.
4. Remove the switch (4) from the panel (1).
Installation Procedure
1. Install the switch (4) into the panel (1).
2. Install the washer (3) and nut (2), and tighten.
3. Install the accessory panel. Refer to Accessory
Instrument Panel (I/P) Replacement in Instrument Panel,
Gages and Console.
4. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
Topper Dome Lamp Switch Replacement –
Rear
Removal Procedure
1. Remove the left rear tail/turn signal lamp. Refer to
Tail/Turn Signal Lamp Replacement (Except Stepside) in
Lighting Systems in 2006 C/K Truck Service Manual.
2. Remove the connector (2) from the switch.
3. From inside the cargo area remove the nut from the
switch.
4. Remove the switch (1) from the vehicle.