Service manual

8-110 Lighting Systems Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the switch (1) into the vehicle.
2. From inside the cargo area install the nut onto the switch.
3. Install the connector (2) onto the switch.
4. Install the left rear tail/turn signal lamp. Refer to Tail/Turn
Signal Lamp Replacement (Except Stepside) in Lighting
Systems in 2006 C/K Truck Service Manual.
Blackout (B/O) Switch Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
2. Remove the accessory panel. Refer to Accessory
Instrument Panel (I/P) Replacement in Instrument Panel,
Gages and Console.
3. Remove the nuts (1) and washers holding the blackout
(B/O) switches.
4. Remove the keyed washers from the accessory panel
and pull the switches out.
Installation Procedure
1. Install the switches through the accessory panel.
2. Install the keyed washers on the switches.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the 2 washers and nuts (1) on the panel.
Tighten
Tighten the 2 nuts to 2.8 N•m (24 lb in).
4. Install the accessory panel. Refer to Accessory
Instrument Panel (I/P) Replacement in Instrument Panel,
Gages and Console.
5. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure.