Service manual

Suspension Front Suspension 3-7
2006 LSSV Service Manual Supplement
2. Verify that the alignment of the jounce lower control arm
(2) and stabilizer bushing link (1) of the factory control
arm are within the specification. Add shims until the
specification is correct.
Specification A
5 mm ± 3.5 mm (0.20 in ±0.14 in).
3. Install the outer shim and control arm brace, ensure that
the pivot nut and brace slots are aligned.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the 2 brace bolts (1) and tighten.
Tighten
Tighten bolts to 72 N•m (53 lb ft).
5. Install the washer and pivot bolt (2).
Tighten
Tighten bolt to 244 N•m (180 lb ft).
6. Verify the control arm pivots freely and that the final
alignment is correct.
7. Install the jounce shock absorber. Refer to Jounce Shock
Absorber Replacement.
8. Install the tire and wheel. Refer to Tire and Wheel
Removal and Installation in Tires and Wheels in 2006
C/K Truck Service Manual.
9. Lower the vehicle. Refer to Lifting and Jacking the
Vehicle in General Information in 2006 C/K Truck Service
Manual.