Service manual

8-112 Lighting Systems Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
Important: The cover hinge must be installed at the 9 O’clock
position.
1. Install the trailer connector (2) and cover (3) onto the
bumper.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the fasteners to secure the cover and connector to
the bumper.
Tighten
Tighten the connector bolts to 5 N•m (44 lb in).
3. Connect the harness connectors (1).
Headlamp Replacement – Blackout (B/O)
(LSSV)
Removal Procedure
1. Remove the nut and washer (3) from the lamp stud at the
base of the mounting bracket.
2. Remove the ground lead (4) by sliding it off the stud.
3. Disconnect the auxiliary wiring harness connector (2)
from the headlamp.
4. Remove the blackout (B/O) lamp assembly (1) from the
mounting bracket.
Installation Procedure
1. Install the blackout (B/O) lamp assembly (1) to the
mounting bracket.
2. Connect the auxiliary wiring harness connector (2).
3. Install the ground lead (4) by sliding it on the stud.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the washer and nut (3) to the lamp stud.
Tighten
Tighten the nut to 10 N•m (89 lb in).