Service manual

8-116 Lighting Systems Body and Accessories
2006 LSSV Service Manual Supplement
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the nuts (2) and the ground connector (3) onto the
mounting studs.
Tighten
Tighten the nuts to 2 N•m (18 lb in).
3. Connect the harness connector (1) to the taillamp
connector.
4. Install the harness into the original mounting location
using the wiring harness strap.
License Plate Lamp Replacement (LSSV)
Removal Procedure
Important: The bulb is not replaceable but is serviced as a lamp
assembly.
1. Ensure the headlamp switch is in the OFF position.
2. Remove the bolts (1) from the lamp.
3. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the lamp and bolts (1) onto the bumper.
Tighten
Tighten the lamp bolts to 0.8 N•m (7 lb in).