Service manual

8-168 Wiring Systems Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the connector to the rear lamp harness.
2. Install the auxiliary rear lamp harness extension along
the path of the existing harness and vehicle frame.
3. Remove supports and lower the vehicle. Refer to Lifting
and Jacking the Vehicle in General Information in the
2006 C/K Truck Service Manual.
4. Install the connector (1) to the I/P auxiliary harness and
wiring harness straps (2) holding to the lamp harness.
5. Install the auxiliary rear lamp extension harness to the
engine compartment location at the left side of the
bulkhead.
6. Connect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
Relay Mounting Bracket Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions
and Notices.
1. Disconnect the battery cables. Refer to Battery Cable
Disconnect/Connect Procedure in Engine Electrical.
2. Remove the left fender upper brace.
3. Remove top cover (2).
4. Remove the electrical center cover assembly (1) by lifting
the cover outwards to clear the tabs (3).
Caution: Approved safety glasses and gloves should be
worn when performing this procedure to reduce the chance
of personal injury.
5. Drill out the rivets (2) and remove bracket (1).