Service manual

3-24 Tires and Wheels Suspension
2006 LSSV Service Manual Supplement
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: The specified torque pattern must be followed to
prevent damage or improper sealing.
Important: Retorque wheel nuts in a star pattern at 80-161 KM
(50-100 MI) and 8047 KM (5,000 MI) thereafter retorque to 102-
108 N•m (75-80 lb ft).
11. Using the torque pattern, tighten the nuts.
Tighten
• Tighten the wheel nuts (first pass) to 81 N•m (60 lb
ft).
• Tighten the wheel nuts (second pass) to 102-108
N•m (75-80 lb ft).
Caution: Allowing pressure to continue to build up within a
tire in an attempt to seat the bead is a dangerous practice
that can result in a broken tire bead and possible serious
injury to the technician.
12. Place the tire in an approved inflation safety cage and
inflate to 30 psi (206 kPa).
13. Check the tire bead seating for space between the wheel
flange and the tire. While the wheel is lying flat, inspect
the entire circumference of the wheel flange. If this
condition exists disassemble and restart by inspecting
the O-ring.
14. Inflate the tire to air pressure and inspect for leaks, by
placing the wheel in a water tank or letting it sit for 48
hours. If the pressure loss is less than 1 psi (7 kPa) the
tire is acceptable for use.
15. Dynamically balance the tire using a maximum balance
weight of 170 g (6 oz) per side. Refer to Tire and Wheel
Assembly Balancing – Off-Vehicle in Vibration Diagnosis
and Correction 2006 C/K Truck Service Manual.