Service manual

Suspension Tires and Wheels 3-31
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the latch bolts (1) on the bumper. Ensure that the
secondary latch cable is also installed and is facing
down.
2. Adjust the carrier latch. Refer to Spare Tire Carrier Latch
Adjustment (Swing Away).
3. Close and ensure that the spare tire carrier is latched.
Spare Tire Carrier Latch Adjustment
(Swing Away)
1. Loosen the latch bolts (1).
2. Swing the carrier into the latch pocket so the striker pin
touches the latch mechanism.
3. Insert a shim (1) between the striker bottom and the latch
pocket.
4. Early carriers with a red striker sleeve will require a 5 mm
(0.20 in) shim, all other carriers with a yellow sleeve will
require a 3 mm (0.12 in) shim.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Secure the latch bolts, ensure that the cable tether is
facing down.
Tighten
Tighten latch bolts to 97 N•m (72 lb ft).
6. Remove the shim (1). The carrier is now aligned and
ready for use.