Service manual

Suspension Tire Pressure Monitoring 3-41
2006 LSSV Service Manual Supplement
Diagnostic Information and
Procedures
DTC E1
Conditions for Setting the DTC
This DTC indicates that there may be broken tire
sensors or a malfunctioning receiver unit. Mismatches
in tire sensor ID may also cause this problem.
DTC E1
DTC Component Symptom Action(s)
E1 Sensor(s) receiver
• Not Transmitting
• RF Section
Malfunction
If no transmission received
within 5 minutes of driving,
contact dealer
DTC E2
Conditions for Setting the DTC
This DTC indicates that there is a problem with the data
in the receiver and/on display units. Causes of this DTC
can include:
• Corrupted custom profile
• Corrupted factory profile
The following may help identify the problem better.
Power the unit OFF and ON.
If the DTC has cleared — Operating with the incorrect
settings. Contact dealer.
If the DTC persists — Receiver or display may have to
be replaced.
DTC E2
DTC Component Symptom Action(s)
E2 Receiver and/or display EEPROM Fault Contact Dealer
DTC E3
Conditions for Setting the DTC
This DTC will usually represent an internal fault. Try
powering the unit OFF and ON to clear this DTC. If this
DTC continuously occur the unit may have to be
replaced.
DTC E3
DTC Component Symptom Action(s)
E3 Receiver and/or display Oscillator Fault Contact Dealer