Service manual

Suspension Tire Pressure Monitoring 3-43
2006 LSSV Service Manual Supplement
Repair Instructions
Tire Pressure Monitoring Receiver
Replacement
Removal Procedure
1. Remove the I/P knee bolster panel. Refer to Knee
Bolster Replacement in Instrument Panel, Gages and
Console in 2006 C/K Truck Service Manual.
2. Disconnect the power cable from the receiver.
3. Disconnect the display cable from the receiver.
4. Remove the bolts (1) and remove the receiver (2).
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the receiver (2) into the bracket and install bolts
(1).
Tighten
Tighten the bolts to 0.8 N•m (7 lb in).
2. Connect the display cable into the receiver.
3. Connect the power cable into the receiver.
4. Install the I/P knee bolster panel. Refer to Knee Bolster
Replacement in Instrument Panel, Gages and Console in
2006 C/K Truck Service Manual.
5. Program the TPMS. Refer to Tire Pressure Monitoring
Sensor Programming.
Tire Pressure Monitoring Gage
Replacement
Removal Procedure
1. Remove the garnish molding. Refer to Garnish Molding
Replacement – Windshield Pillar in Interior Trim in 2006
C/K Truck Service Manual.
2. Remove the push pins (1) from the gage housing.
3. Pull the housing (2) out enough to remove the gage
electrical connectors.
4. Remove the housing from the vehicle.