Service manual

3-44 Tire Pressure Monitoring Suspension
2006 LSSV Service Manual Supplement
5. Remove the nuts (1) from the back of the gage.
6. Remove the gage bracket (2).
7. Remove the gage from the housing.
Installation Procedure
1. Install the gage into the housing opening.
2. Install the bracket (2) on the back of the gage.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the nuts (1) on the gage studs.
Tighten
Tighten the nuts to 0.8 N•m (7 lb in).
4. Install the electrical connectors onto the gage.
5. Install the housing (2) onto the garnish molding and
install the push pins (1).
6. Install the garnish molding. Refer to Garnish Molding
Replacement – Windshield Pillar in Interior Trim in 2006
C/K Truck Service Manual.