Service manual

Suspension Tire Pressure Monitoring 3-45
2006 LSSV Service Manual Supplement
Tire Pressure Monitoring Switch Panel
Replacement
Removal Procedure
1. Remove the I/P knee bolster panel. Refer to Knee
Bolster Replacement in Instrument Panel, Gages and
Console in 2006 C/K Truck Service Manual.
2. Disconnect the switch panel cable from the receiver.
3. Remove any wiring harness straps securing the cable to
the vehicle.
Note position of straps for reinstallation.
4. Pull the switch Panel off of the instrument panel cluster
(IPC) trim plate bezel.
5. Remove the switch panel (1), routing panel cable through
the hole in the IPC bezel.
Note cable routing position for reinstallation.
Installation Procedure
1. Apply Velcro strip to the back of the new switch panel.
2. Install the switch panel (1), routing panel cable through
the hole in the IPC bezel in the same locations as
removed.
3. Press the switch panel in place on the instrument panel
cluster (IPC) trim plate bezel.
4. Connect the switch panel cable to the receiver and
secure with wiring harness straps in the same locations
as removed.
5. Install the I/P knee bolster panel. Refer to Knee Bolster
Replacement in Instrument Panel, Gages and Console in
2006 C/K Truck Service Manual.
6. Verify correct operation of the Tire Pressure Monitoring
System.
Tire Pressure Monitor Sensor
Replacement
Removal Procedure
Caution: Refer to Vehicle Lifting Caution in Cautions and
Notices.
1. Raise the vehicle. Refer to Lifting and Jacking the
Vehicle in General Information in 2006 C/K Truck Service
Manual.
2. Remove the affected wheel. Refer to Tire and Wheel
Removal and Installation in Tires and Wheels in 2006
C/K Truck Service Manual.
3. Remove the pressure transmitter sensor assembly. Refer
to Tire Mounting and Dismounting (Beadlock) in Tires
and Wheels.