Service manual

3-50 Tire Pressure Monitoring Suspension
2006 LSSV Service Manual Supplement
Tire Rotation
Important: This function is used after the tires are rotated and
the new position needs to be updated. This procedure is valid for
four tire locations only.
1. Enter Level 1 Programming Mode. Refer to Entering
Programming Modes.
2. To enter, press the MODE button until the tire rotation
icon is displayed.
3. Press the TIRE button to scroll to a tire position.
Important: The current tire position number will be displayed.
4. Press the MODE button to select it for editing.
5. Use the TIRE or MODE button to adjust the value to the
number determined in step 4.
6. Press the SET button when the number representing the
desired sensor is achieved. This returns the display to
the tire selection menu. Scroll to a different tire location
and edit the sensor numbers as above.
7. Press the SET button to save and exit this mode.
Important: If more than one tire location contains the same
sensor number, the display will prompt an error with the
conflicting tires filled in and the associated sensor number.
8. Press any button to return the tire selection menu and
make necessary corrections.
Important: This display indicates that ID 1 is programmed in two
locations causing the error.
9. Press the SET button again to revert to normal mode.