Service manual

Suspension Tire Pressure Monitoring 3-51
2006 LSSV Service Manual Supplement
Level 2
Slope
For Tire Pressure Setting Specifications refer to Tire Inflation
Pressure Specifications in Maintenance and Lubrications.
Important: Factory Default 44. The slope is a value
corresponding to the rate of pressure change due to temperature
for a particular tire. This value affects the calculation to
determine pressure deviation value.
1. Enter Level 2 Programming Mode. Refer to Entering
Programming Modes.
2. Press the TIRE button to scroll to the desired axle, the
tires of the selected axle are filled in.
3. Press the MODE button to display the current value of
slope for the selected axle.
4. Press the TIRE button to increase the value.
5. Press the MODE button to decrease the value.
The minimum value is 10 and the maximum is 160.
6. Press the SET button to save the value.
Important: Repeat steps 2-6 until the slope level is set for all
axles desired.
7. Press the SET button to exit.
8. Press the SET button again to revert to normal mode.
Learn Mode
Important: This mode is used to add or remove transmitters
from the system.
Learn Procedure W/O Special Tool
1. Enter Level 2 Programming Mode. Refer to Entering
Programming Modes.
2. Press the MODE button to select the learn mode icon.
3. Press the TIRE button to display the ten possible wheel
positions for the towing vehicle. The currently installed
transmitter positions are now indicated with a filled in tire
indicator.
4. Use the TIRE button to scroll to the desired position. The
outline of the wheel position to be programmed will flash.